The Back-UPS ES is shipped with one battery wire disconnected in ES APC, Back-UPS and PowerChute are registered trademarks of American Power. APC Back-UPS ES, VA/W, Input V/ Output V,. Interface Port USB Manual, USB cable, Velcro Cord Management Straps, Wall- mounting. system, computer and the Back-UPS. Back-UPS™. / User’s Manual. 4/ APC Shutdown Manager software has been designed specifically to.
|Published (Last):||12 June 2014|
|PDF File Size:||3.55 Mb|
|ePub File Size:||1.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
The Back-UPS is not connected to utility power, there is no utility power available at the wall outlet, or the utility power is experiencing a brownout or over voltage condition.
Perhaps the users of Apc back-ups es 350 manual. Do not expect full battery run capability during the initial charge time.
APC Back-UPS ES 350 manual
The model and serial numbers are located on the rear panel of the unit and are available through the LCD display on select models. APC pays ground freight transportation costs to ship the replacement unit to the customer. APC standard procedure is to replace the original unit with a factory reconditioned unit. Table of Contents Page: Never use foam beads for packaging. The Back-UPS battery is completely discharged.
When utility power is restored the battery will recharge. One at apc back-ups es 350 manual time reconnect equipment to the Back-UPS. Deliver used batteries to a battery apc back-ups es 350 manual facility in the packaging provided by APC with the replacement battery cartridge.
It is not intended for alc with motor driven equipment. Make sure the power cord is securely connected to the wall outlet, and that there is utility power available at the wall outlet.
Do not use a surge protector or an extension cord. It is normal for small sparks to be seen when the battery cable is connected to the battery terminal. Contact APC at ees Web site www.
Apc back-ups es 350 manual a computer, monitor and other peripheral devices to the outlets. Use this setting under normal conditions.
fs The battery is not connected. Remove all nonessential equipment connected to the outlets. PowerChute software has performed a shutdown due to a power failure.
The more precies your question is, the higher the chances of quickly receiving an apc back-ups es 350 manual from another user. This se normal Back-UPS operation. Connect the Back-UPS power cord directly to a wall outlet. APC will ship the replacement unit once the defective unit has been received by the repair department, or cross-ship upon the receipt of a valid credit card number.
Customers who must have the original unit back due to the assignment of asset tags and set depreciation schedules must declare such a need at first contact with an APC Technical Support representative.
The output waveform is intended for computers and ,anual devices. Previous apc back-ups es 350 manual Next page. Program mode is no back–ups active. Battery backup outlets receive power from the Back-UPS for a limited period of time when a power outage, or brownout condition occurs.
To order replacement battery cartridges contact APC through the Web site www. English Ask a question. The battery is near the end of useful life and should be replaced. Low Battery warning The Back-UPS is supplying battery power to the battery backup outlets and the battery is near a total discharge state.
The beeping stops when: Do not operate this unit in direct sunlight, apc back-ups es 350 manual contact with fluids, or where there is excessive dust or humidity. If the unit is under warranty, the repairs are free. Overload Shutdown While on battery power an overload condition has occurred in one or more of the battery backup outlets while the Back-UPS is operating on battery power.
As a battery ages, the runtime capability decreases. Connect the Back-UPS to a wall outlet.
Damage manuao in transit is not covered under warranty. The LED is not illuminated during the beeps. The connection from the Back-UPS to the internet is lost during a power outage The modem has lost power.
The Back-UPS may require service. Note the model number and serial number and the date of purchase.
APC Back-UPS ES manual
Have a qualified electrician correct the building wiring fault. Slide the battery cover off.
Refer to apc back-ups es 350 manual table for an explanation of the transfer voltage sensitivity levels. The Back-UPS is operating normally on battery power. Return the unit by insured, pre-paid carrier to the address provided by Customer Support.
Connect a printer, scanner or other peripheral devices that do not need to remain on during power outages, or utility problems to the surge protection outlets. The Building Wiring Fault LED illuminates The building wiring presents a shock hazard apc back-ups es 350 manual must be corrected by a qualified electrical.
Review the Troubleshooting section of the manual to eliminate common problems. To exit Program mode wait five seconds and all LED indicators will extinguish. The customer pays for shipping the unit to APC.
The Back-UPS battery is near a total discharge state.