Allen-Bradley NI8 I/O Module, Analog, 8 Channel Input, 24VDC. Allen- Bradley NI8 I/O Module, Mfr Number: NI8. Rexel Part Number: The NI8 analog I/O module contains 8 inputs (-+10V DC, -+20mA). The backplane current load of NI8 is mA at 5V DC or mA at 24V DC. NI8 Low Price Guarantee! Allen Bradley – Rockwell Automation SLC ALBNI8 New, Repair and Reman Parts. Ships Fast and 2 YR Warranty.
|Country:||Turks & Caicos Islands|
|Published (Last):||4 June 2015|
|PDF File Size:||3.2 Mb|
|ePub File Size:||15.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
NI8 Analog Input Module | SLC In-Stock. Ships Today – Santa Clara Systems
The NI8 module has an 8-Channel input with an isolated backplane. Connect the other end of the cable to the voltage or current transmitter terminals. Sign up for a new account in our community.
Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. Repeat steps 1 through 6 for each channel on the module. To wire your NI8 module follow these steps.
How would I know the scaling format for the analog values coming from the SN module. It is suitable for time-sensitive applications that require fast analog signal conversion and high accuracy. Care should be taken to avoid connecting a voltage source to a current input module. This makes it clear. This end of the cable is connected to one of the shield terminals on the NI8 module. Please help me interpret the scaling of my NI8 inputs. It has a maximum backplane power consumption of 1 Watt at 5 Volts DC and 2.
The initial confusion was decyphering between the different formats: Does this module have a terminal block? SLC Module Type: After the analog input module is properly installed in the chassis, follow the wiring procedure below using Belden cable.
Complain wrong Brand wrong Model non readable. I did not see it in the NI8 user manual or installation manual. The NI8 module uses programmable filter frequencies with a low-pass digital filter for input filtering.
D Micro Programmable Logic Controllers.
Can this module be purchased with a warranty? It performs continuous autocalibration and has an isolation voltage of Volts DC mi8 Volts AC, tested for 60 seconds. It is a high-resolution analog input module with high-density components and it can be configured by the user with software. Share this post Link to post Share on other sites. Trim the signal wires to 50 mm 2 inch lengths.
This is probably where the confusion came from. It can be converted to digital operation with successive approximation and using the switched capacitor.
NI8 scaling – Allen Bradley –
Please contact us for additional information. Wiring Input Devices to the NI8. In Stock Ships Today. It has a 174 voltage ranging from to 10 Volts with a maximum of 15 Volts between any two terminals.
ALLEN BRADLEY 1746-NI8 / 1746NI8, SLC 500 analog input module (o.D.)
Posted 8 Aug Some of the channels are scaled to and others are scaled to At one end of the cable, twist the drain hi8 and foil shield together. The cable has a maximum loop impedance of 40 Ohms at the voltage source and Ohms at the current source.
When assessing an existing program, all analog inputs are set up as documented, but they use different raw values when scaling e. Cable Cut foil shield and drain wire. Sign in Already have an account? Twist the drain wire nj8 foil shield together and connect to earth ground or to the shield terminal on the NI8 module.